เครื่องควบคุมอุณหภูมิพร้อมเซนเซอร์ DC12V Digital LED Temperature Controller 10A Thermostat Control Switch Probe
บอร์ดควบคุมอุณหภูมิ ใช้สำหรับควบคุมช่วงอุณภูมิที่ต้องการ ตามที่กำหนด ย่านการควบคุมอุณหภูมิอยู่ในช่วง -50 ถึง 110 องศาเซลเซียสFeatures:


Supply voltage: 12V
Temperature range: -50-110 degree
Control accuracy: 0.1 degree
Load power: 120/240 / 1500W
Measuring input: NTC10K waterproof probe L = 1Meter
Output Type: Direct output
Output capacity: Up to 10A
Installation pitch: 73mm (aperture 4mm)
Dimensions: 60 * 45 * 31mm

  12v Wiring: Tip: 12V DC power supply or you can use a transformer power supply 12V output Note: The product is directly output, so when the output terminals are not connected load, do not energized, to prevent contact with two wires and ignition What is a direct output: This thermostat output and input voltage are synchronous, meaning that the thermostat in the operating state (lights), How much input voltage and How much is the output voltage directly.When the thermostat (lights out) in the work, the output end there will be no voltage output   Intelligent judgment modes of operation: Start temperature Start temperature> stop temperature = cooling mode Heating mode setting mode: Setting Tips: Start temperature   Setting mode: 1. Long Press up button, start the temperature of the flash,Through up and down keys to set the start temperature 2.Long Press Down button, stop the temperature of the flash,Through up and down keys to set the stop temperature Use case:Control water heaters, heated to 65 degrees to stop, the temperature dropped to 50 degrees to start heating again, how to set? Step 1: Determine the operating mode for the heating mode, starting temperature Step Two: long Press the up button, the temperature starts flashing up and down keys to set the starting temperature of 50 degrees The third step: Press the button down, the temperature stops flashing, stop by the arrow keys to set the temperature to 65 degrees, setting is completed. Cooling mode is set up:Setting Tips: Start temperature> stop temperature (the program automatically determines the operating mode to cooling mode) Setting mode: 1. Press the button on the key to start the temperature of the flash, up and down keys to set the start temperature 2. Long press the key button to stop temperature flash, stop up and down keys to set the temperature valueUse case: Control farms, ventilate to 26 degrees stopped, the temperature rose to 28 degrees start cooling again, how to set? Step 1: Determine the operating mode is a cooling mode, starting temperature> stop temperature Step Two: Long Press the button raised, the temperature starts flashing up and down keys to set the starting temperature of 28 degrees The third step: Press the button down, the temperature stops flashing, set the stop up and down keys to a temperature of 26 degrees set. Tip: set the heating mode, if you do not accidentally set the temperature set value is inverted, the output light is off, the load does not work, if there is the case after setting above, you can check the temperature value is not reversed .   package include:


1pc -50-110 Degree Heat Cool Digital Thermostat

  รับประกันสินค้า 15 วัน